How to Change the Battery on SanDisk MP3 Players

How to Change the Battery on SanDisk MP3 Players
Page content

SanDisk Sansa Fuze

If your SanDisk Sansa Fuze is under warranty, stop here and contact the manufacturer. If you open the SanDisk Sansa Fuze, it will void your warranty. If it is not under warranty then proceed with the steps below. As with most small electronics, changing the battery is not easy. It takes time and some patience. You will need a knife with a length of ½ inch or less, an eyeglass screwdriver set, or you could use a jeweler’s set and small needle nosed pliers.

On a flat, clean surface find the small clips on the side of the SanDisk Sansa Fuze. You will find these clips in the creases on each side and at the bottom crease. The bottom two clips may be glued down. With the knife, gently press the first clip inward and gently pry the case apart. Do this for all clips one at a time.

Pull the top panel upward very slowly and gently. When you lift this panel watch for the ribbon cable. This cable holds the top and bottom of the MP3 player together. Take the needle nosed pliers and grasp the bar of the cable that is attached to the top half of the MP3 player. Disconnect the cable from the socket. Make sure you only grab the bar on the cable and not the wires. At this point the top plate should be completely removed from your SanDisk MP3 player.

Sansa Fuze Battery

You should see the battery on the back plate of the SanDisk player. The battery is flat and rectangular in shape and has one red, black and white wire on one side. Use the jeweler’s screwdriver and very gently pry the battery off the sticky foam. Take the new battery, press it in the socket and reconnect the ribbon cable back into the socket. Next, line up the top and bottom of the plate and make sure the clips line up and press the plate down to the bottom plate. Do not be forceful but press gently. Snap the clips back in place one at a time.

SanDisk Sansa View

If your SanDisk Sansa View is still under warranty then stop here. If you open the Sansa View it voids out your warranty.

You should see a circle on the bottom right side of the Sansa View. Use a needle (or something like it) to remove the rubber cover. Under this cover is the screw that holds the entire Sansa View together. Use a small bladed knife, or you can purchase a cell phone opening tool (probably better) and run it around the Sansa view counter clockwise if the screen is facing you. Do not force this. You may need to try more than one time. It can be frustrating to remove the cover but you have to keep trying. There are small retention clips so make sure you don’t break these.

Now it starts getting tricky. You need to lift the LCD ribbon cable on the opposite side. This exposes the battery. The battery is actually soldered in underneath the black tape. The area is very small and the soldering iron will have to have a small tip.

Sansa View Battery

You definitely need to have soldering experience if you want to replace the battery. It is very tricky and very easy to break your SanDisk MP3 player so be very careful.

SanDisk Sansa Clip

You really can’t replace the battery for your SanDisk Sansa Clip. There may be ways out there but it is recommended you do not change the battery yourself. If it is still under warranty then you can have it changed free of charge. If it is not, you will need to contact the retailer or purchase a new Sansa Clip, whichever is cheaper.

Sansa Clip